ISITMAX
Schnee- und Eisfreihaltung
Snow and Ice Melting Under Concrete
Snow and Ice Melting Under Concrete keeps the entire surface of an outdoor area free of snow and ice using a 350 W/m² electric hea
ab €795 $920Produkt ansehen →
Schnee- und Eisfreihaltung
Stair and Building Entrance Heating
Stair and Building Entrance Heating is a system that keeps outdoor stair treads, landings and the flat area in front of the door free of snow and ice with a 350 W/m² electric heater buried…
Richtpreis · ab
€795 / $920
Richtpreis ab Werk Istanbul, zzgl. MwSt., Fracht und Zoll. Umgerechnet vom TRY-Listenpreis zum angegebenen Kurs; verbindlich erst im Angebot.
Kurs vom: 2026-09-15
Verfügbare Größen
- TMaxPro cable + fixing strip
- ProMat ready-made mat
Verfügbare Größen
- 4 m2
- 5 m2
- 6 m2
- 7 m2
- 8 m2
- 9 m2
- 10 m2
- 15 m2
- 20 m2
- 25 m2
- 30 m2
- 40 m2
- 50 m2
Verfügbare Größen
- Ekoline
- Proline
- Maxline
Überblick
Stair and Building Entrance Heating is a system that keeps outdoor stair treads, landings and the flat area in front of the door free of snow and ice with a 350 W/m² electric heater buried beneath the covering. The heater is either TMaxPro cable laid to the geometry of the treads or, on flat landings, ProMat mat; the two are the same cable, deliver the same power and cost exactly the same per square metre. The system runs by itself from a control panel with moisture and temperature sensors — nobody has to get up early to shovel the steps.
In a courtyard, ice makes a vehicle skid; on a staircase it makes a person fall. That is why there is no partial solution on stairs: if nine of ten treads are clear and one is icy, the system has not done its job. The heating covers every horizontal surface a pedestrian steps on.
Auf einen Blick
Treads, landings and the door approach togetherEvery horizontal surface a pedestrian steps on is heated; not even a single icy tread is left.
350 W/m² outdoor snow melting powerSnow melts faster than it falls, and the meltwater drains away without refreezing on the tread.
No salt or shovel requiredNatural stone and granite treads are damaged by salt; heating solves the problem without touching the surface at all.
Automatic control that detects precipitationIt switches on when snow starts and off when the surface dries. Our own CE-certified manufacture since 1995.
Einsatzbereiche
TMaxPro cable + fixing strip
The only practical solution on tread geometry
TMaxPro cable + fixing strip The cable comes at the calculated length together with its fixing strip. It runs without a break from tread to tread, is spaced closer at the nosing and wider at the back, and passes through conduit at transitions. Even if the tread dimensions are out by a few centimetres, the laying spacing is adjusted on site.
ProMat ready-made mat
Shortens the laying work on landings and at the door
ProMat ready-made mat The same cable comes laid out at the correct spacing on a stiff mesh, in 50 and 100 cm widths. On a flat landing the roll is unrolled and fixed down; at turns only the mesh is cut. It is the quickest option if only the flat area in front of the door is to be heated.
Technische Daten
| Property | Value |
|---|---|
| Product, application, output | Snow and ice melting system for outdoor stairs, landings and building entrances · TMaxPro cable + fixing strip or ProMat ready-made mat · 350 W/m²cable is recommended on stepped geometry and mat on a flat landing; the price is the same for both |
| Heated area and connected load | 4 – 50 m² · from 1,400 W to 17,500 Wthe area is the sum of the horizontal surfaces only; risers are not counted |
| Heated surfaces | Tread top surface and nosing · landing · intermediate half-landing · door approach and doormat area · the walking surface at the foot of the stairsthe risers and the 15 cm at the edge are not heated |
| Supply and protection | 220 – 240 V AC, 50 Hz · IP67 · two layers of polymer insulation · continuous earth protection and screening · 30 mA residual current device (RCD) mandatory |
| Laying rules | 6 – 8 cm target cover beneath the covering · closer spacing towards the tread nosing · transitions between treads inside protective conduit · at least 15 cm from the edge of the covering · runs must not crossthe sensor is placed in conduit on the surface that warms up last |
| Control | Ekoline temperature sensor only · Proline ISITMAX panel with moisture + temperature sensors · Maxline Eberle panel with moisture + temperature sensors · run-on 30 – 120 minutesthe control panel is included in the price |
| Operating behaviour | Pre-heating 1 – 2 hours before precipitation · first effect on the surface in 30 min – 1 hour · complete clearing in 4 – 6 hours in most cases · not to be operated before the mortar and screed have dried |
| Manufacture and warranty | Our own CE-certified production since 1995 · 10-year SafeMax warranty on the heating element · control panel, sensors and fixing strip 2 years |
Ist dies das richtige Produkt?
Passend, wenn
- You have an outdoor staircase, landing or flat area in front of a door and icing creates a pedestrian safety problem in winter.
- The staircase is being newly built or its covering renewed — the heater goes beneath the covering; it is not applied over an existing surface.
- The covering is natural stone, granite, ceramic or concrete and you do not want to use salt.
- The heated area is between 4 and 50 m²; treads, landing and door approach are calculated together.
- The location is one that carries liability — the entrance to an apartment building, a housing complex, a hotel, a hospital or a public building.
Nicht geeignet, wenn
- If you are heating a whole ramp or a courtyard — Snow and Ice Melting Under Concrete is dimensioned for that geometry.
- If you are heating only the vehicle wheel tracks — Ramp Wheel-Track Heating gives the same power at a much lower connected load.
- If you do not want to lift the existing covering — the heater is buried beneath the covering, not laid over it.
- For a roof, gutter or downpipe — roof and gutter snow melting is a separate product.
- If you are heating an internal staircase or an enclosed hallway — 350 W/m² is far too high for an enclosed space; see the floor heating family.
Installation
- PreparationThe tread concrete and the landing are levelled and the surface is cleaned. The surfaces to be heated and the edge margins are marked out; the transition points between treads are established and protective conduits put in place. The panel position and the cold lead route are planned from the outset — once the staircase is finished, pulling cable is not possible.
- LayingOn each tread surface the cable is laid with closer spacing towards the nosing and wider spacing towards the back, and fixed to the strip. Transitions from tread to tread are made inside conduit; sharp turns are avoided. If mat is used on the landing, the roll is unrolled and taped down. The sensor conduit is placed on the surface that warms up last.
- Connection, testing, coveringThe cold leads are run to the panel; an electrician makes the connection, the supply is taken through a 30 mA residual current device, and the earth screen is bonded to the busbar. An ohm test is carried out before the covering is laid and the result is recorded. Once the test is passed, the mortar and covering are applied; the system is commissioned in stages after the mortar has dried completely.
The ohm test is carried out before the covering goes on, not after. If the resistance is not within the expected range, nothing is covered over. Reaching a fault on a staircase later means lifting the tread covering.
Bestellung und Lieferung
- same dayHeater type, heated area and control panel are specified and the order placed
- 1 working dayThe staircase sketch arrives; the number of treads, the width, the depth and the landing dimensions are confirmed
- 1–2 working daysThe heater is prepared to the tread layout and the cold leads are brought out towards the panel
- 2–4 working daysHandover to the carrier, tracking number, delivery throughout Türkiye
- as requiredTechnical support during laying, resistance testing and commissioning of the panel
Garantie und Support
Stair and Building Entrance Heating is a CE-certified product of ISITMAX's own manufacture, carried on since 1995; we ship throughout Türkiye.
Häufige Fragen
Are the risers heated as well?
No. The heating covers horizontal surfaces only: tread tops, the landing and the door approach. Nobody steps on the vertical face of a riser and snow does not settle there; heating it would waste energy. Risers are not counted in the heated area calculation either.
How do I work out how many square metres to select?
Find the tread area from number of treads × staircase width × tread depth, then add the landing and the flat area in front of the door. A staircase with 8 treads, 1.4 m wide and 32 cm deep comes to 3.58 m²; together with a 2.24 m² landing that is about 5 m².
Why should the bottom tread and the foot of the stairs be heated too?
Because water runs downhill under gravity. If the heating stops at the upper treads, the meltwater freezes on the unheated lower tread and you have simply moved the ice to the most dangerous point. The heated area is extended to the walking surface at the foot of the stairs and, where there is one, as far as the drain.
Can it be applied to my existing staircase?
Yes, if the covering is being renewed: the existing covering is lifted, the heater is laid and the new covering goes down. Application without lifting the covering is not possible; the heater goes beneath the surface, not over it.
Can it be used on natural stone and granite treads?
Yes — they are in fact the most suitable coverings. Stone conducts heat well, and because it is damaged by salt, heating is the only real alternative to salt here. The heater does not touch the stone directly; there is mortar or adhesive in between.
Ähnliche Produkte
Schnee- und Eisfreihaltung
Snow and Ice Melting Cable
Snow and ice melting cables are electric heating cables laid beneath the ground or a metal surface to prevent snow build-up and ic
ab €5 $5Produkt ansehen →
Schnee- und Eisfreihaltung
Ramp Wheel-Track Heating
Ramp Wheel-Track Heating is a snow melting system that keeps only the two strips the vehicle wheels run on free of snow and ice on
ab €885 $1 020Produkt ansehen →
Angebot anfordern
Beschreiben Sie die Anwendung — wir legen das System aus und erstellen ein Angebot.