ISITMAX
السخانات المرنة والأغطية الحرارية
Industrial Electric Drum Heating Jacket 200 L / 215 L
The drum heating jacket is a flexible electric heater that wraps the full body of 200, 215 and 220 litre drums.
ابتداءً من €480 $555عرض المنتج →
السخانات المرنة والأغطية الحرارية
Heated Pipe Jacket
A heated pipe jacket is a sleeve slipped over a process pipe from the outside that both insulates and heats, closes with clasps and can be removed when required.
سعر استرشادي · ابتداءً من
€285 / $325
سعر استرشادي تسليم المصنع إسطنبول، غير شامل الضريبة والشحن والرسوم. محوّل من سعر القائمة بالليرة التركية وفق السعر المبيّن، ويُعتمد نهائياً في عرض السعر.
سعر الصرف بتاريخ: 2026-09-15
المقاسات المتاحة
- DN10 – DN50
- DN50 – DN150
المقاسات المتاحة
- 40cm
- 70cm
- 100cm
- 150cm
- 200cm
- 300cm
نظرة عامة
A heated pipe jacket is a sleeve slipped over a process pipe from the outside that both insulates and heats, closes with clasps and can be removed when required. By wrapping the pipe it reduces heat loss, and the heating element inside makes up the remaining difference. That is its only difference from fixed insulation: when work on the line is needed, the jacket is not cut away — the clasps are opened, and it is refitted when the job is done.
A heated pipe jacket is a flexible sleeve that wraps around the pipe. It contains a heating element and a layer of insulation, and its outer face is closed with a hard covering able to withstand site conditions. The jacket is slipped over the pipe, its clasps are closed, and when power is applied that section of pipe heats up.
لمحة سريعة
Hard outer coveringOuter surface Protects the inner layers against abrasion, chemical splashing and mechanical impact in an industrial environment. The surface is cleaned by wiping.
IP65Protection rating Fully protected against dust and resistant to water jets from any direction. This is not a <i>waterproof</i> rating — the jacket must not be immersed or operated under water.
−40 °C / +60 °CAmbient temperature The jacket is made to operate within this ambient temperature range. It is used outdoors, around cold stores and in open plant areas.
What a heated pipe jacket does
أين يُستخدم
Against freezing
To maintain flowability
On most of these lines the storage side is heated along with the pipe. For tank, drum and IBC solutions, see the tank and drum heating page.
المواصفات الفنية
| Item | Detail |
|---|---|
| Warranty | 2 years |
| Protection class | IP65 |
| Ambient temperature | −40 °C to +60 °C |
| Diameter bands | DN10 – DN50 · DN50 – DN150 |
| Stock lengths | 40 · 70 · 100 · 150 · 200 · 300 cm |
| Custom-size production | Production time is confirmed at the quotation stage |
| Pricing | Per unit, excluding VAT |
| Contact | WhatsApp and info@isitmax.com |
دليل الاختيار
Which diameter and length should you choose?
| Diameter band | Suitable nominal pipe diameter | Inch equivalent | Typical use |
|---|---|---|---|
| DN10 – DN50 | DN10, DN15, DN20, DN25, DN32, DN40, DN50 | 3/8″ – 2″ | Dosing and sampling lines, chemical feed, small-bore process pipework |
| DN50 – DN150 | DN50, DN65, DN80, DN100, DN125, DN150 | 2″ – 6″ | Main process and transfer lines, pump inlets and outlets, tank connections |
التركيب
Fitting a heated pipe jacket needs no welding, cutting or special tools. Follow the sequence without changing it.
Electrical connection: The jacket supply must always be taken through a residual current device. Earthing must not be omitted. Have the connection made by a qualified electrician.
الأسئلة الشائعة
Which diameters does the heated pipe jacket fit?
There are two diameter bands: DN10–DN50 (3/8″–2″) and DN50–DN150 (2″–6″). The choice is made by the nominal diameter of the pipe. For pipes above DN150 the jacket is made to measure.
Which lengths do you sell?
There are six stock lengths: 40, 70, 100, 150, 200 and 300 cm. If your measurement falls in between, round up to the next length. For single pieces longer than 300 cm, production is made to measure.
Can I remove the jacket and refit it?
Yes, that is exactly what the product is designed for. You isolate the supply, let the jacket cool, open the clasps, set it aside, and refit it when the work is finished. The same jacket is used on the same pipe again and again.
Do I need to add insulation over the jacket?
No. The insulation is part of the jacket's own construction. Wrapping additional material over it prevents heat escaping and causes the jacket to overheat; the jacket must be left uncovered.
My pipeline already has heating cable — is a jacket also needed?
For long straight runs, cable is the right solution. A jacket is for short sections that are worked on frequently — around pumps, at measuring points and on dead legs. The two are not alternatives but are used together.
منتجات ذات صلة
السخانات المرنة والأغطية الحرارية
Mirror Heating Film
The mirror heating film is a 1 mm thick carbon heating film bonded to the back of bathroom, hotel, spa and hammam mirrors, warming
ابتداءً من €10 $10عرض المنتج →
السخانات المرنة والأغطية الحرارية
Industrial Canister Heating Jacket
The canister heating jacket is a flexible electric heating wrap that encloses a 120 litre canister from the outside, rated at 800
ابتداءً من €450 $520عرض المنتج →
السخانات المرنة والأغطية الحرارية
Industrial IBC Tank Heating Jacket — 1,000 Litres
The IBC tank heating jacket is an industrial heating jacket that wraps a 1,000 litre caged IBC tank on all four sides.
ابتداءً من €655 $760عرض المنتج →
اطلب عرض سعر
صف لنا التطبيق وسنقوم بتحديد مقاس النظام وتسعيره.